TX RX Fórum
Registe-se, faça a sua apresentação e terá acesso total ao TX&RX Fórum. ___________________________ Apresente-se dizendo quem é, escreva algo sobre si. Exemplo: Nome, indicativo, nome de estação, localidade, o que mais gosta de fazer no mundo das radio-comunicações e outras coisas que ache importante para a sua apresentação. Se é novato não tenha vergonha de o dizer, pois cá estamos para o ajudar.
___________________________ O TX&RX Fórum destina-se à publicações de mensagens "posts" relacionados com todos os assuntos sobre Radio Frequência. Essas mensagens têm como objectivo promover ideias, experiências, projectos, esclarecer duvidas, divulgação de actividades e publicações de novidades sobre Radio Comunicações.
Divirta-se!!
Siga no Facebook

RELÓGIO



Divulgação


GEK SSB HF Transceiver

Ir em baixo

GEK SSB HF Transceiver

Mensagem por ALF007 em Sab 24 Out 2015 - 21:29

[Você precisa estar registrado e conectado para ver esta imagem.]

(Diamond series will challenge the commercial transceivers)

Design Goals
These transceivers circuit design follows a standard well-proven approach based on various design & kits available on WWW and modifications have been done.An approach has been made by combining each and every stage of circuit of Ten-tec, Kenwood, Elecraft,Icom etc studied pro’s and con’s formed a new design to give an ultimate high performance HF transceiver to Indian hams.

Silver series (Low range) for Beginners:
- Electric homebrewed pipe Mic
- Power amplifier with IRF510/ IRF250 transistors
- SA602 Front end mixer with Single side PCB

Gold series (Mid range) for Amateurs:
- Dynamic Mic / Audio Compression 1:1 to 15:1
- Variable IF Band-with 400Hz to 3000Hz
- Variable IF Gain Control
- Power amplifier (RD06HHF1 as driver and two RD16HHF1 as PA)
- Double side PTH PCB

Diamond series (High range) for Professionals: (a challenge to commercial transceivers)
- Double balanced diode mixer for excellent dynamic range
- Dynamic Mic / Audio Compression 1:1 to 15:1
- Variable IF Band-with 400Hz to 3000Hz
- Variable IF Gain Control
- Pre amp on/off, Attenuator on/off, Agc auto/ manual ,Agc fast /slow
- Variable AF Filter
- Noise blanker Add on
- Pushpull Power amplifier (RD06HHF1 as driver and RD16HHF1 as PA)
- SWR Protection
- Double side PTH PCB

The GEK mono band series is a high performance , Commercial grade SSB low cost HF transceiver covering entire any one or multi of 160M-10M HF band. The local oscillator is stable DDS VFO. The transceiver comes with inbuilt SWR /Power Meter with digital display readout. Audio compression for excellent transmit audio intelligibility.This circuit design follows a standard well-proven approach based on various design & kits available on WWW modifications have been done.
Considering better IMD and clean linear signal ,power amplifier is based on Mitsubishi RD06HHF1 as driver and a pair of RD16HHF1 as a push-pull.

Features & specification :

GEK1C: Any One Bands
- Receive sensitivity: 0.8µV
- DDS VFO of tuning step 10,100Hz &1,10,100KHz
- 16 x 2 Digital Lcd display SWR /Signal / Power / Frequency readout
- Variable-bandwidth receive crystal filter, approx. 400-3000 Hz
- 7-pole, 2.2 kHz Transmit crystal filter
- Narrow double-tuned bandpass filters
- Switchable Attenuator
- Audio Compression range 1:1 to 15:1
- IF BW & IF Gain
-Rugged 10-20Watts-PEP,SWR protected, PA RF transistors
-5Watts audio output built in high efficiency speaker
- 600Ω / 300 to 3000Hz / 120 ± 3dB Dynamic PTT microphone
- SIZE : 180mm (L) x 200mm (W) x 65mm (H)
- Weight : 1.5Kgs
- 12-14 VDc
- Reverse – polarity protection, Internal self-resetting fuse

[Você precisa estar registrado e conectado para ver esta imagem.]

The GEK dual band series is a high performance , Commercial grade SSB low cost HF transceiver covering entire any two of 160M-10M HF band. The local oscillator is stable DDS VFO. The transceiver comes with inbuilt SWR /Power Meter with digital display readout. Audio compression for excellent transmit audio intelligibility.This circuit design follows a standard well-proven approach based on various design & kits available on WWW modifications have been done.
Considering better IMD and clean linear signal ,power amplifier is based on Mitsubishi RD06HHF1 as driver and a pair of RD16HHF1 as a push-pull.

GEK2A: Bands 40m / 20m
GEK2B: Any two Bands

- Receive sensitivity: 0.8µV
- DDS VFO of tuning step 10,100Hz &1,10,100KHz
- 16 x 2 Digital Lcd display SWR /Signal / Power / Frequency readout
- Variable-bandwidth receive crystal filter, approx. 400-3000 Hz
- 7-pole, 2.2 kHz Transmit crystal filter
- Narrow double-tuned bandpass filters
- Switchable Attenuator
- Audio Compression range 1:1 to 15:1
- IF BW & IF Gain
- Rugged 10-20Watts-PEP,SWR protected, PA RF transistors
- 5Watts audio output built in high efficiency speaker
- 600Ω / 300 to 3000Hz / 120 ± 3dB Dynamic PTT microphone
- SIZE : 180mm (L) x 200mm (W) x 65mm (H)
- Weight : 1.5Kgs
- 12-14 VDc
- Reverse – polarity protection, Internal self-resetting fuse

- Link

__________________________________
Qualquer duvida exponha no Fórum.
Vamos ajudar-lhe.
Com as suas duvidas, vamos aprender!
Por isso existe o
[Você precisa estar registrado e conectado para ver esta imagem.]     ... 73's
[Você precisa estar registrado e conectado para ver esta imagem.]

Siga o Facebook TX&RX Fórum
.... O meu canal
You Tube

Instagram
TX&RX DX Grupo
31TX007 - Classe 3
PMR265
avatar
ALF007
Administrador Fundador


Voltar ao Topo Ir em baixo

Re: GEK SSB HF Transceiver

Mensagem por nineâu5 em Dom 25 Out 2015 - 12:11

Sad só que eles não metem preços nem representantes em portugal.. adorei o radio
avatar
nineâu5
Profissional


Voltar ao Topo Ir em baixo

Voltar ao Topo


 
Permissão deste fórum:
Você não pode responder aos tópicos neste fórum